Home › Vehicle Interior › HEATING / AIR CONDITIONING › RELAY(for Cooling Fan Control)
RM1880E _58 Vehicle Interior _013245 HEATING / AIR CONDITIONING _0068688 RELAY(for Cooling Fan Control) G

HEATING / AIR CONDITIONING  RELAY(for Cooling Fan Control)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.REMOVE CONDENSER FAN RELAY

a.
E235396
2.75,2.25 2.75,2.5 true 2.677,2.5 2.854,2.677 0.177,0.177 10 false *1
*1 Condenser Fan Relay


Remove the condenser fan relay from the engine room relay block.


Hide 2.INSPECT CONDENSER FAN RELAY

E277662
1.667,1.104 1.99,1.125 true 2.365,1.438 2.479,1.688 true 2.667,1.167 3.021,1.271 true 2.375,0.802 2.625,0.438 true 0.281,1.229 0.438,1.427 0.156,0.198 10 false 1 0.281,0.813 0.438,1.01 0.156,0.198 10 false 3 1.292,1.24 1.448,1.438 0.156,0.198 10 false 2 1.302,0.813 1.458,1.01 0.156,0.198 10 false 5 1.542,1.021 1.698,1.219 0.156,0.198 10 false 3 2.542,1.698 2.698,1.896 0.156,0.198 10 false 2 3.052,1.24 3.208,1.438 0.156,0.198 10 false 5 2.667,0.302 2.823,0.5 0.156,0.198 10 false 1

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the condenser fan relay.



Hide 3.INSTALL CONDENSER FAN RELAY

a.

Install the condenser fan relay to the engine room relay block.