Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.INSTALL COOLER (SOLAR SENSOR) THERMISTOR (for Automatic Air Conditioning System)
2.INSTALL NOISE SHUTTER SEAL
Clean the instrument panel surface.
Align 2 new noise shutter seals with the markings on the upper instrument panel and install the noise shutter seals to the positions shown in the illustration using a double-sided tape.
3.INSTALL INSTRUMENT PANEL BOX
Install the instrument panel box with the 3 screws <A>.
4.INSTALL INNER NO. 1 INSTRUMENT PANEL REINFORCEMENT
Install the inner No. 1 instrument panel reinforcement with the 8 screws <A>.
5.INSTALL METER MOUNTING BRACKET
Install the meter mounting bracket with the screw <A>.