Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
1.INSTALL CONSOLE BOX ASSEMBLY
| *1 | Screw |
| *2 | Bolt |
| *3 | Clip |
Install the console box with the 4 screws and 2 bolts.
Install the 2 clips.
2.INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
Attach the 12 claws to install the upper console panel.
| *A | for Manual Transmission | *B | for Automatic Transmission |
3.INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY
Attach the 4 claws to install the parking brake hole cover.
4.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)
Install the shift lever knob and twist it in the direction indicated by the arrow.