Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.INSTALL NO. 1 ROOF WIRE
Position the positioning tape as shown in the illustration and install the No. 1 roof wire.
Apply tape in the order shown in the illustration to fix the No. 1 roof wire in place.
Adjust any slack of the No. 1 roof wire as indicated by the dashed lines in the illustration and apply tape.
| *1 | Positioning Tape | - | - |
2.INSTALL ROOF HEADLINING PACKING
| *1 | Roof Headlining Packing |
| *2 | Marking |
Use the same procedure for both roof headlining packings.
Align a new roof headlining packing with the marking on the roof headlining and install the roof headlining packing to the position shown in the illustration using double-sided tape.
3.INSTALL ROOF HEADLINING PACKING
| *1 | Roof Headlining Packing |
| *2 | Marking |
Align a new roof headlining packing with the marking on the roof headlining and install the roof headlining packing to the position shown in the illustration using double-sided tape.
4.INSTALL ROOF HEADLINING PACKING
| *1 | Roof Headlining Packing |
| *2 | Marking |
Use the same procedure for both roof headlining packings.
Align a new roof headlining packing with the marking on the roof headlining and install the roof headlining packing to the position shown in the illustration using double-sided tape.
5.INSTALL ROOF HEADLINING PACKING
| *1 | Roof Headlining Packing |
| *2 | Marking |
Use the same procedure for both roof headlining packings.
Align a new roof headlining packing with the markings on the roof headlining and install the roof headlining packing to the position shown in the illustration using double-sided tape.
6.INSTALL ROOF HEADLINING PACKING
| *1 | Roof Headlining Packing |
Install a new roof headlining packing to the position shown in the illustration using double-sided tape.
7.INSTALL NO. 1 AIR OUTLET REGISTER ASSEMBLY
| *1 | Bracket |
| *2 | No. 1 Air Outlet Register |
Use the same procedure for all No. 1 air outlet registers.
Attach the 4 claws to install the bracket and No. 1 air outlet register.
Install the 2 screws.