Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)
RM1880E _59 Vehicle Exterior _013248 WINDOW / GLASS _0068699 POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function) J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)  Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)  


DESCRIPTION

If the door glass or the front power window regulator motor assembly RH does not operate smoothly, the jam protection function may be triggered automatically, resulting in the auto up function being unable to fully close the window.

HINT:

The jam protection function is only available on the driver side power window.


WIRING DIAGRAM

B276696
5.385,2.854 6.979,3.313 1.594,0.458 10 false Power Window Regulator Master Switch Assembly 0.271,2.917 2.26,3.333 1.99,0.417 10 false Front Power Window Regulator Motor Assembly RH 0.896,1.177 1.323,1.448 0.427,0.271 10 false PLS 5.646,0.646 6.063,0.906 0.417,0.26 10 false VCC 5.646,1.167 6.083,1.354 0.438,0.188 10 false PLS 5.646,1.667 6.146,1.896 0.5,0.229 10 false PLS2 5.646,2.188 6.083,2.438 0.438,0.25 10 false GND 0.583,1.698 1.135,2.031 0.552,0.333 10 false PLS 1.75,0.594 1.99,0.823 0.24,0.229 10 false 4 1.75,1.094 2.063,1.375 0.313,0.281 10 false 5 1.76,1.594 1.958,1.833 0.198,0.24 10 false 3 1.76,2.094 1.948,2.302 0.188,0.208 10 false 6 1.281,0.771 1.781,1 0.5,0.229 10 false SSRB 1.396,1.292 1.833,1.552 0.438,0.26 10 false PLS 1.313,1.802 1.771,1.99 0.458,0.188 10 false PLS2 1.552,2.302 1.771,2.531 0.219,0.229 10 false E 5.448,0.583 5.625,0.771 0.177,0.188 10 false 3 5.396,1.094 5.688,1.365 0.292,0.271 10 false 14 5.396,1.594 5.75,1.906 0.354,0.313 10 false 17 5.448,2.115 5.656,2.302 0.208,0.188 10 false 2 0.271,2.74 0.667,2.99 0.396,0.25 10 false H2 5.385,2.667 5.708,2.927 0.323,0.26 10 false H8

PROCEDURE

1.RESET FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH
a.

Reset the front power window regulator motor assembly RH.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>INITIALIZATION


b.

Check that the power window auto up/down function operates normally.

OK:

Auto up/down function operates normally.



Result:
Proceed to
OK
NG



OK

END

NG

2.CHECK WINDOW GLASS SLIDING MOVEMENT (APPLICABLE LOCATION)
2.CHECK WINDOW GLASS SLIDING MOVEMENT (APPLICABLE LOCATION)
a.

Remove the front power window regulator motor assembly RH.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW REGULATOR MOTOR(for Front Door)>REMOVAL


b.

Install the window glass to the door glass run.


c.

Check if the power window regulator operates smoothly.


d.

Check that the window glass slides smoothly when sliding it up by hand.

OK:

Window glass slides smoothly.



CAUTION:

Reset the front power window regulator motor assembly RH again.


HINT:

Make sure that the following conditions are met:

·

The window glass fits with the glass run without improper contact or deformation.

·

Foreign objects are not caught in the glass run.



Result:
Proceed to
OK
NG



OK

END (PROBLEM DUE TO RESET FAILURE)

NG

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH