CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (WINDOW LOCK SWITCH)
Before performing the window lock switch operation check, make sure that the window lock switch is off (the switch is not pushed in).
Check that the front passenger side power window and the rear power windows cannot be operated when the window lock switch of the power window regulator master switch assembly is pressed.
Operation of front passenger side power window and rear power windows is disabled.
Check that the front passenger side power window and the rear power windows can be operated when the window lock switch is pressed again.
Front passenger side power window and rear power windows can be operated.
CHECK MANUAL UP/DOWN FUNCTION
Check that the driver side power window operates as follows:
| Condition | Power Window Regulator Master Switch Assembly | Switch Operation | Power Window Operation |
|---|---|---|---|
| Ignition switch ON | Driver side | Pulled up | Up (Closes) |
| Pushed halfway down | Down (Opens) |
Check that the front passenger side power window and rear power windows operate as follows:
| Condition | Power Window Regulator Switch Assembly | Switch Operation | Power Window Operation |
|---|---|---|---|
·
Ignition switch ON ·
Window lock switch off |
Front passenger side | Pulled up | Up (Closes) |
| Pushed down | Down (Opens) | ||
| Rear LH side | Pulled up | Up (Closes) | |
| Pushed down | Down (Opens) | ||
| Rear RH side | Pulled up | Up (Closes) | |
| Pushed down | Down (Opens) |
CHECK AUTO DOWN FUNCTION
Check that the driver side power window operates as follows:
| Condition | Power Window Regulator Master Switch Assembly | Switch Operation | Power Window Operation |
|---|---|---|---|
| Ignition switch ON | Driver side | Fully pushed down | Auto down (Fully opens) |
CHECK REMOTE MANUAL UP/DOWN FUNCTION
Check that the front passenger side power window and rear power windows operate as follows:
| Condition | Power Window Regulator Master Switch Assembly | Switch Operation | Power Window Operation |
|---|---|---|---|
·
Ignition switch ON ·
Window lock switch off |
Front passenger side | Pulled up | Up (Closes) |
| Pushed down | Down (Opens) | ||
| Rear LH side | Pulled up | Up (Closes) | |
| Pushed down | Down (Opens) | ||
| Rear RH side | Pulled up | Up (Closes) | |
| Pushed down | Down (Opens) |
CHECK PTC OPERATION
PTC operation is a function that prevents overloading of the power window regulator by stopping the power window motor. PTC operation activates when the power window regulator switch is operated for a predetermined amount of time.
Disconnect the power window regulator motor.
Connect the ammeter's positive (+) lead to terminal 2 of the wire harness side connector and the negative (-) lead to battery's negative terminal.
Connect the battery's positive (+) lead to terminal 1 of the wire harness side connector, and raise that window to the fully closed position.
Continue to apply voltage, and check that the current changes to less than 1A within 4 to 90 seconds.
Disconnect the leads from the terminals.
Approximately 60 seconds later, connect the battery's positive (+) lead to terminal 2 and the negative (-) lead to terminal 1, and check that the window begins to lower.
If the result is not as specified, replace the power window regulator motor.