1.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
| *1 | LED |
| *a | Component without harness connected
(Power Window Regulator Master Switch Assembly) |
w/ Jam Protection Function:
Check that the LED illuminates.
Apply battery voltage to the power window regulator master switch assembly and check that the LED illuminates.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 6 (B)
Battery negative (-) → 1 (E) |
LED illuminates |
If the result is not as specified, replace the power window regulator master switch assembly.
| *1 | LED |
| *a | Component without harness connected
(Power Window Regulator Master Switch Assembly) |
w/o Jam Protection Function:
Check that the LED illuminates.
Apply battery voltage to the power window regulator master switch assembly and check that the LED illuminates.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 6 (B)
Battery negative (-) → 3 (E) |
LED illuminates |
If the result is not as specified, replace the power window regulator master switch assembly.