1.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
| *a | Component without harness connected
(Rear Power Window Regulator Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 5 (D) - 4 (SD)
2 (U) - 3 (B) |
up | Below 1 Ω |
| 5 (D) - 4 (SD)
2 (U) - 1 (SU) |
off | Below 1 Ω |
| 5 (D) - 3 (B)
2 (U) - 1 (SU) |
down | Below 1 Ω |
If the result is not as specified, replace the rear power window regulator switch assembly.