Home › Vehicle Exterior › DOOR / HATCH › HOOD
RM1880E _59 Vehicle Exterior _013249 DOOR / HATCH _0068712 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

HINT:
·
B286201
0.656,1.729 0.948,1.938 0.292,0.208 10 false *1 2.552,1.76 2.865,2.01 0.313,0.25 10 false *2
*1 Centering Bolt
*2 Standard Bolt


Centering bolts are used to mount the hood hinge to the vehicle body and hood. The hood cannot be adjusted with the centering bolts on. Substitute the centering bolts for standard bolts (with washers) when making adjustments.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 1.ADJUST HOOD SUB-ASSEMBLY

a.
B276672

Adjust the hood position.

i.

Loosen the 4 hinge bolts on the hood and adjust the hood position.


ii.

Move the hood and adjust the clearance between the hood and front fender.


iii.

Tighten the 4 hinge bolts on the hood after the adjustment.

Torque:
12 N*m (117 kgf*cm, 8.5 ft.*lbf)



b.
B280269

Adjust the cushion rubbers so that the hood and fender are aligned.

HINT:

Raise or lower the front end of the hood by turning the cushion rubber.



c.
B286137

Adjust the hood lock.

i.

Loosen the 3 bolts.


ii.

Adjust the hood lock position so that the striker can enter it smoothly.


iii.

Tighten the 3 bolts after the adjustment.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)