Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY(for LHD)
RM1880E _59 Vehicle Exterior _013249 DOOR / HATCH _0068718 HOOD LOCK CONTROL CABLE ASSEMBLY(for LHD) A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY(for LHD)  REMOVAL  


PROCEDURE

Hide 2.REMOVE HOOD LOCK ASSEMBLY

a.
B280284

Remove the 3 bolts.


b.
B280285

Disconnect the hood lock control cable and remove the hood lock.


Hide 3.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.
B280286

Detach the 3 claws.


b.

Disconnect the hood lock control cable and remove the hood lock control lever.


Hide 4.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY

a.
B277362
1.719,1.323 2.458,1.323 false 1.479,1.208 1.781,1.417 0.302,0.208 10 false *1
*1 String


Tie a string to the end of the hood lock control cable as shown in the illustration.

HINT:

Use a length of string long enough to pass through the engine compartment.



b.

Detach each clamp and the grommet, and then pull out the hood lock control cable from the vehicle body.


c.

Untie the string from the hood lock control cable.

B280287
5.885,4.292 6.104,4.406 false 5.75,5.24 5.49,4.906 false 4.917,5.5 4.656,5.5 true 3.156,5.25 2.896,5.208 true 1.594,3.802 1.365,3.917 true 1.469,1.719 1.24,1.854 true 1.5,1.604 1.802,1.823 0.302,0.219 10 false *1 1.615,3.677 1.917,3.896 0.302,0.219 10 false *1 3.208,5.146 3.479,5.365 0.271,0.219 10 false *1 4.948,5.417 5.25,5.646 0.302,0.229 10 false *1 5.813,5.167 6.094,5.385 0.281,0.219 10 false *1 5.656,4.177 5.917,4.396 0.26,0.219 10 false *2
*1 Hood Lock Control Cable *2 Grommet