Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR COVER
RM1880E _59 Vehicle Exterior _013250 MIRROR (EXT) _0068722 OUTER REAR VIEW MIRROR COVER A

MIRROR (EXT)  OUTER REAR VIEW MIRROR COVER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL OUTER MIRROR COVER LH

a.
B280815

Attach the 2 claws as shown in the illustration.


b.

Attach the 6 claws to install the mirror cover LH.


c.
B278385

After installing the outer mirror cover, check that there is no gap between the cover and mirror body.

HINT:

If there is a gap between the cover and body, noise will occur during driving.



d.

Install the 3 screws.


e.
B278444
1.427,0.24 1.302,0.344 1.302,0.344 1.052,0.344 false 0.927,1.521 0.927,1.719 false 2.573,1.771 2.5,1.927 2.5,1.927 2.354,1.927 false 0.823,0.229 1.073,0.51 0.25,0.281 10 false *1 0.854,1.781 1.115,1.99 0.26,0.208 10 false *1 2.104,1.813 2.344,2.021 0.24,0.208 10 true *1
*1 Adhesive


Using a T25 "TORX" socket wrench, install the 3 screws.

HINT:
·

Clean the threads of the screw with non-residue solvent.

·

Apply adhesive to the threads of the screw.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent





f.

Attach the 10 claws.


g.

Install the rubber base with the screw.


h.
B278446
1.115,1.25 1.24,1.615 1.24,1.615 1.5,1.615 false 0.979,0.448 1.271,0.667 0.292,0.219 10 false *a 1.573,1.521 1.792,1.708 0.219,0.188 10 false *1
*1 Tape
*a 40 mm (1.58 in.)


Apply new tape as shown in the illustration.


Hide 3.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH