Home › Vehicle Exterior › MIRROR (EXT) › OUTER MIRROR SWITCH
RM1880E _59 Vehicle Exterior _013250 MIRROR (EXT) _0068723 OUTER MIRROR SWITCH G

MIRROR (EXT)  OUTER MIRROR SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT OUTER MIRROR SWITCH ASSEMBLY

B203252
1.385,3.708 0.813,4.115 true 1.625,3.708 1.417,4.104 true 1.76,3.698 1.802,4.094 true 1.885,3.698 2.25,4.104 true 1.5,3.708 1.083,4.104 true 2,3.698 2.635,4.104 true 2.125,3.708 3.125,4.094 true 2.24,3.625 2.802,3.26 true 1.115,3.635 0.74,3.292 0.74,3.292 1.25,3.615 true 2.104,0.958 2.563,0.958 true 0.24,2.219 0.583,2.479 0.344,0.26 10 false *a 2.615,0.844 2.969,1.021 0.354,0.177 10 false *b 0.729,4.135 0.958,4.333 0.229,0.198 10 false B 1.26,4.135 1.604,4.333 0.344,0.198 10 false M+ 1,4.135 1.208,4.313 0.208,0.177 10 false E 1.573,4.135 1.938,4.313 0.365,0.177 10 false MLH 2.063,4.135 2.521,4.333 0.458,0.198 10 false MLV 2.49,4.135 2.927,4.313 0.438,0.177 10 false MRV 3,4.135 3.427,4.365 0.427,0.229 10 false MRH 2.875,3.156 3.375,3.344 0.5,0.188 10 false No Pin 0.24,3.177 0.771,3.385 0.531,0.208 10 false No Pin
*a Component without harness connected
(Outer Mirror Switch Assembly)
*b Select switch


a.

Inspect the outer mirror switch.

i.

Select "L" on the select switch.


ii.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
4 (MLV) - 8 (B)
6 (M+) - 7 (E)
UP Pressed Below 1 Ω
Not pressed 10 kΩ or higher
4 (MLV) - 7 (E)
6 (M+) - 8 (B)
DOWN Pressed Below 1 Ω
Not pressed 10 kΩ or higher
5 (MLH) - 8 (B)
6 (M+) - 7 (E)
LEFT Pressed Below 1 Ω
Not pressed 10 kΩ or higher
5 (MLH) - 7 (E)
6 (M+) - 8 (B)
RIGHT Pressed Below 1 Ω
Not pressed 10 kΩ or higher


If the result is not as specified, replace the outer mirror switch assembly.


iii.

Select "R" on the select switch.


iv.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (MRV) - 8 (B)
6 (M+) - 7 (E)
UP Pressed Below 1 Ω
Not pressed 10 kΩ or higher
3 (MRV) - 7 (E)
6 (M+) - 8 (B)
DOWN Pressed Below 1 Ω
Not pressed 10 kΩ or higher
2 (MRH) - 8 (B)
6 (M+) - 7 (E)
LEFT Pressed Below 1 Ω
Not pressed 10 kΩ or higher
2 (MRH) - 7 (E)
6 (M+) - 8 (B)
RIGHT Pressed Below 1 Ω
Not pressed 10 kΩ or higher


If the result is not as specified, replace the outer mirror switch assembly.