Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM
RM1880E _59 Vehicle Exterior _013251 WIPER / WASHER _0068725 WIPER AND WASHER SYSTEM D

WIPER / WASHER  WIPER AND WASHER SYSTEM  SYSTEM DESCRIPTION  


WASHER LINKED OPERATION


a.

This system operates the front wipers at low speed immediately after spraying a jet of washer fluid when the front washer switch is turned on for 0.3 seconds or more. The system operates the front wipers at low speed for approximately 2.2 seconds and then stops operation when the washer switch is turned on for 1.5 seconds or more.



INTERMITTENT OPERATION


C242293
0.438,0.635 1.573,1.344 1.135,0.708 10 false Windshield Wiper Switch Assembly 2.438,0.313 4.198,0.656 1.76,0.344 10 false Windshield Wiper Switch 5.323,0.5 6.365,1.083 1.042,0.583 10 false Windshield Washer Switch 0.104,4.115 1.646,4.542 1.542,0.427 10 false from Ignition Switch 1.917,4.26 2.292,4.479 0.375,0.219 9 false WIP 2.219,3.667 2.563,4.021 0.344,0.354 9 false +B 2.531,3.667 2.948,4.052 0.417,0.385 9 false +2 2.844,3.667 3.208,4.042 0.365,0.375 9 false +1 3.073,3.667 3.49,4 0.417,0.333 9 false +S 3.469,3.646 3.906,3.979 0.438,0.333 9 false C1 5.406,3.01 5.875,3.323 0.469,0.313 9 false C2 5.156,2.365 5.438,2.635 0.281,0.271 9 false Tr2 4.583,2.823 4.917,3.083 0.333,0.26 9 false Tr1 1.969,1 2.365,1.198 0.396,0.198 9 false OFF 1.99,1.135 2.365,1.385 0.375,0.25 9 false INT 2.01,1.292 2.271,1.479 0.26,0.188 9 false LO 2.031,1.438 2.375,1.74 0.344,0.302 9 false HI 1.938,0.844 2.458,1.094 0.521,0.25 9 false MIST 2.354,0.688 2.698,0.938 0.344,0.25 9 false +B 2.646,0.688 2.896,0.906 0.25,0.219 9 false +2 2.969,0.688 3.271,0.99 0.302,0.302 9 false +1 3.24,0.688 3.563,0.948 0.323,0.26 9 false +S 3.49,0.688 3.969,0.969 0.479,0.281 9 false INT1 3.823,0.688 4.365,1.031 0.542,0.344 9 false INT2 4.188,0.688 4.75,1.083 0.563,0.396 9 false B1 5.375,1.438 5.729,1.656 0.354,0.219 9 false OFF 5.406,1.281 5.771,1.531 0.365,0.25 9 false ON 5.76,1.135 5.979,1.354 0.219,0.219 9 false W 6,1.135 6.292,1.365 0.292,0.229 9 false EW 5.51,3.688 6.042,4.031 0.531,0.344 9 false WF 4.552,4.281 5.813,5.094 1.26,0.813 10 false Windshield Washer Motor and Pump Assembly 2.167,5.292 3.396,5.792 1.229,0.5 10 false Windshield Wiper Motor Assembly 6.167,3.688 6.708,4.104 0.542,0.417 9 false EW

a.

The system operates the front wipers once in approximately 1.6 to 10.7 seconds when the front wiper switch is turned to the INT position. The intermittent time can be adjusted from 1.6 to 10.7 seconds by using the intermittent time adjust dial.


b.

If the windshield wiper switch (front wiper switch) is turned to the INT position, current flows from the already charged capacitor C1 through terminals INT1 and INT2 of the front wiper switch to Tr1 (transistor). When Tr1 turns on, current flows from terminal +S of the front wiper switch to terminal +1 of the front wiper switch, to terminal +1 of the windshield wiper motor, to the windshield wiper motor and finally to ground, causing the windshield wiper motor to operate. At the same time, current flows from capacitor C1 to terminal INT1 of the front wiper switch and then INT2. When the current flow from capacitor C1 ends, Tr1 turns off to stop the relay contact point and halt the windshield wiper motor.

When the relay contact point turns off, capacitor C1 begins to charge again and Tr1 remains off until charging has been completed. This period corresponds to the intermittent time. When capacitor C1 is fully charged, Tr1 turns on and then the relay contact point turns on, causing the windshield wiper motor to operate again. This cycle is the intermittent operation.

The intermittent time can be adjusted by using the intermittent time adjust dial (variable resistor) to change the charge time of capacitor C1.