1.INSPECT REAR WIPER MOTOR ASSEMBLY
Check the wiper operation.
Connect the battery's positive (+) lead to terminal 1 (B) and the negative (-) lead to terminal 2 (+1), and check that the motor operates.
Motor operates.
If the result is not as specified, replace the motor assembly.
Check the automatic stop operation.
Connect the battery's positive (+) lead to terminal 1 (B) and the negative (-) lead to terminal 2 (+1). With the motor rotating, disconnect terminal 1 (B) to stop the wiper motor operation at the automatic stop position.
| *a | Automatic Stop Position |
Check that the motor stops automatically at the automatic stop position.
| Standard Area | Standard Condition |
|---|---|
| A | 112° to 118° |
Refer to illustration.
If the result is not as specified, replace the motor assembly.