Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE(for Rear)
RM1880E _59 Vehicle Exterior _013251 WIPER / WASHER _0068734 WASHER NOZZLE(for Rear) G

WIPER / WASHER  WASHER NOZZLE(for Rear)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT REAR WASHER NOZZLE SUB-ASSEMBLY

a.

With the engine running, check that the center stream of washer fluid sprays on the back door glass within the hatched area shown in the illustration.

Standard:

Washer fluid hits the back door glass in the area shown in the illustration.


E226583
5.156,0.813 5.156,0.552 false 4.771,1.271 4.885,1.396 4.885,1.396 5.052,1.396 false 4.948,3.021 4.948,2.844 4.948,2.844 5.354,2.844 false 4.833,3.063 4.833,3.302 false 5.104,0.833 5.396,1.135 0.292,0.302 10 false *1 5.104,1.323 5.542,1.729 0.438,0.406 10 false *2 2.667,2.76 2.948,3.042 0.281,0.281 10 false A 3.604,3.271 3.875,3.594 0.271,0.323 10 false B 5.406,2.771 5.656,3.021 0.25,0.25 10 false *1 4.792,3.344 5.115,3.573 0.323,0.229 10 false *2
*1 Ceramic Line *2 Wiper Pattern


Standard:
Area Specified Condition
A 39 mm (1.53 in.)
B 100 mm (3.97 in.)


If the result is not as specified, replace the rear washer nozzle.