Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY
RM1880E _59 Vehicle Exterior _013252 LIGHTING (EXT) _0068740 REAR COMBINATION LIGHT ASSEMBLY A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH

a.

Attach the guide.


b.

Attach the connector clamp to install the rear combination light socket and wire sub-assembly LH.


Hide 2.INSTALL TAIL AND STOP LIGHT BULB

a.
E227312

Install the tail and stop light bulb to the rear combination light socket and wire sub-assembly LH.


b.

Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow in the illustration to install the socket.


Hide 3.INSTALL BACK UP LIGHT BULB

a.
E227313

Install the back up light bulb to the rear combination light socket and wire sub-assembly LH.


b.

Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow in the illustration to install the socket.


Hide 4.INSTALL REAR TURN SIGNAL LIGHT BULB

a.
E227314

Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly LH.


b.

Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow in the illustration to install the socket.


Hide 5.INSTALL REAR COMBINATION LIGHT GASKET LH

a.

Install a new rear combination light gasket LH.


Hide 6.INSTALL REAR COMBINATION LIGHT ASSEMBLY LH

a.

Connect the connector.


b.

Attach the 2 pin.


c.

Install the 2 bolts to install the rear combination light assembly LH.