Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH
RM1880E _59 Vehicle Exterior _013252 LIGHTING (EXT) _0068744 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY (w/o Display)

a.
E155916
2.26,0.708 1.969,1.125 true 1,1.135 1.302,1.135 true 0.094,0.094 0.49,0.438 0.396,0.344 10 false *a 2.333,0.604 2.49,0.781 0.156,0.177 10 false E 0.74,1.052 1.208,1.448 0.469,0.396 10 false TB
*a Component without harness connected
(Hazard Warning Signal Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
2 (E) - 4 (TB) off 10 kΩ or higher
2 (E) - 4 (TB) on Below 1 Ω

If the result is not as specified, there may be a malfunction in the hazard warning signal switch.


Hide 2.INSPECT INTEGRATION PANEL SUB-ASSEMBLY (w/ Display)

a.
E226171
0.896,1.281 1.25,1.281 true 2.156,1.125 2.521,1.125 true 0.177,0.135 0.438,0.396 0.26,0.26 10 false *a 2.583,1.042 3.073,1.323 0.49,0.281 10 false GND 0.531,1.198 1.021,1.469 0.49,0.271 10 false SW1
*a Component without harness connected
(Integration Panel Sub-assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (GND) - 16 (SW1) off 10 kΩ or higher
1 (GND) - 16 (SW1) on Below 1 Ω

If the result is not as specified, there may be a malfunction in the integration panel sub-assembly.