Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING SWITCH
RM1880E _59 Vehicle Exterior _013252 LIGHTING (EXT) _0068745 HEADLIGHT LEVELING SWITCH G

LIGHTING (EXT)  HEADLIGHT LEVELING SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT HEADLIGHT LEVELING SWITCH

a.
E190512
2.125,1.219 2.427,1.177 true 1.865,1.365 2.042,1.646 true 1.552,1.354 1.354,1.688 true 1.24,1.198 0.885,1.229 true 0.167,0.104 0.615,0.302 0.448,0.198 10 false *a 2.479,1.094 2.667,1.271 0.188,0.177 10 false B 2.01,1.646 2.167,1.823 0.156,0.177 10 false T 1.208,1.688 1.5,1.865 0.292,0.177 10 false ILL+ 0.729,1.135 0.885,1.313 0.156,0.177 10 false E
*a Component without harness connected
(Headlight Leveling Switch)


Connect the positive (+) lead of the battery to terminal 1 (B) and the negative (-) lead to terminal 2 (E).


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
1 (B) - 2 (T) 0 10.4 to 11.2 V
1 9.16 to 9.88 V
2 7.88 to 8.60 V
3 6.60 to 7.32 V
4 5.32 to 6.04 V
5 4.04 to 4.76 V



c.

Apply battery voltage to the connector and check the LED illumination condition.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 3 (ILL+)
Battery negative (-) → 4 (E)
LED illuminates


If the result is not as specified, replace the headlight leveling switch.