Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH
RM1880E _59 Vehicle Exterior _013252 LIGHTING (EXT) _0068746 STOP LIGHT SWITCH A

LIGHTING (EXT)  STOP LIGHT SWITCH  INSTALLATION  


PROCEDURE

Hide 1.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

a.

Install the stop light switch mounting adjuster to the pedal support.


Hide 2.INSTALL STOP LIGHT SWITCH ASSEMBLY

a.
F049043
1.208,1.198 1.448,1.323 false 0.583,1.198 0.583,1.375 false 1.448,1.323 1.448,1.542 false 2.042,1.354 2.042,1.74 false 1.365,1.542 1.656,1.813 0.292,0.271 10 *2 0.51,1.385 0.802,1.615 0.292,0.229 10 *1 1.969,1.76 2.25,2.01 0.281,0.25 10 *3
*1 Brake Pedal
*2 Adjuster
*3 Stop Light Switch Assembly


Install the stop light switch assembly to the adjuster until the switch body slightly touches the brake pedal.

NOTICE:

Do not depress the pedal.



b.
E202046
1.021,0.135 0.865,0.135 0.865,0.135 0.552,0.698 false 1.885,1.26 1.885,1.479 false 1.104,0.063 1.479,0.313 0.375,0.25 10 false *1 0.5,1.74 0.813,2.021 0.313,0.281 10 false *a 1.823,1.531 2.115,1.771 0.292,0.24 10 false *2
*1 Shaft
*2 Stop Light Switch
*a 1.5 to 2.5 mm


Rotate the stop light switch assembly clockwise so that the clearance is between 1.5 to 2.5 mm (0.0590 to 0.0984 in.) as shown in the illustration.

NOTICE:
·

Do not depress the pedal.

·

The turning torque of installing the stop light switch assembly should be 1.5 N*m (15 ft.*lbf, 13 in.*lbf) or less.




c.

Check the stop light switch assembly clearance.

Stop light switch clearance:

1.5 to 2.5 mm (0.059 to 0.098 in.)



d.

Connect the connector to the stop light switch assembly.