Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH
RM1880E _59 Vehicle Exterior _013252 LIGHTING (EXT) _0068746 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT STOP LIGHT SWITCH ASSEMBLY

E065594
0.094,1.083 0.313,0.813 true 2.563,0.333 2.802,0.729 true 2.948,0.729 3.156,0.333 true 3.177,0.177 3.354,0.427 0.177,0.25 10 false 1 2.458,0.177 2.76,0.427 0.302,0.25 10 false 2 0.115,0.094 0.375,0.375 0.26,0.281 10 false *a 0.083,1.604 0.417,1.875 0.333,0.271 10 false *b 0.042,1.156 0.333,1.448 0.292,0.292 10 false *1 0.656,1.625 0.99,1.938 0.333,0.313 10 false *c
*1 Shaft
*a Component without harness connected
(Stop Light Switch Assembly)
*b Not Pushed
*c Pushed


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - 2 Shaft not pushed Below 1 Ω
Shaft pushed 10 kΩ or higher


If the result is not as specified, replace the stop light switch assembly.