Home › Vehicle Exterior › LIGHTING (EXT) › TURN SIGNAL FLASHER ASSEMBLY
RM1880E _59 Vehicle Exterior _013252 LIGHTING (EXT) _0068747 TURN SIGNAL FLASHER ASSEMBLY G

LIGHTING (EXT)  TURN SIGNAL FLASHER ASSEMBLY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK TURN SIGNAL FLASHER ASSEMBLY

a.
E162022
2.052,1.708 2.396,1.156 true 1.104,1.729 0.396,1.125 true 1.167,2.208 0.635,2.875 true 1.74,2.25 1.375,2.948 true 2,2.25 2.344,2.938 true 1.458,2.25 0.979,2.938 true 2.292,2.25 2.771,2.938 true 2.344,1.75 2.667,1.75 true 0.271,0.208 0.604,0.448 0.333,0.24 10 false *a 0.354,2.896 0.833,3.177 0.479,0.281 10 false HAZ 1.281,2.99 1.625,3.25 0.344,0.26 10 false ER 2.302,3 2.594,3.219 0.292,0.219 10 false EL 2.469,1.042 2.823,1.292 0.354,0.25 10 false LR 0.198,1.031 0.563,1.292 0.365,0.26 10 false LL 0.896,3 1.24,3.26 0.344,0.26 10 false E 2.76,3 3.052,3.219 0.292,0.219 10 false B 2.75,1.667 3.104,1.917 0.354,0.25 10 false IG
*a Front view of wire harness connector
(to Turn Signal Flasher Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
7 (E) - Body ground Always Below 1 Ω



b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
2 (LR) - 7 (E) Hazard warning switch off Below 1 V
Hazard warning switch on Alternating between 11 to 14 V and below 1 V
(60 to 120 times per minute)
3 (LL) - 7 (E) Hazard warning switch off Below 1 V
Hazard warning switch on Alternating between 11 to 14 V and below 1 V
(60 to 120 times per minute)
4 (B) - 7 (E) Always 11 to 14 V
5 (EL) - 7 (E) Ignition switch ON
Headlight dimmer switch (turn left) off
9 V or higher
Ignition switch ON
Headlight dimmer switch (turn left) on
Below 1 V
6 (ER) - 7 (E) Ignition switch ON
Headlight dimmer switch (turn right) off
9 V or higher
Ignition switch ON
Headlight dimmer switch (turn right) on
Below 1 V
8 (HAZ) - 7 (E) Hazard warning switch off 9 V or higher
Hazard warning switch on Below 1 V


If the result is not as specified, there may be a malfunction in the turn signal flasher.