Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ENGINE HOOD MOULDING
RM1880E _59 Vehicle Exterior _013254 EXTERIOR PANELS / TRIM _0068757 ENGINE HOOD MOULDING A

EXTERIOR PANELS / TRIM  ENGINE HOOD MOULDING  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL FRONT NO. 1 HOOD MOULDING PAD LH

HINT:

When installing the front No. 1 hood moulding pad, heat the front hood moulding surface using a heat light.


Standard:
Item Temperature
Front Hood Moulding 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the front hood moulding excessively.


a.

Clean the front hood moulding surface.

i.

Using a heat light, heat the front hood moulding surface.


ii.

Remove the double-sided tape from the front hood moulding surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.
B280275

Install a new front No. 1 hood moulding pad.

i.

Remove the peeling paper from the face of a new front No. 1 hood moulding pad.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



ii.

Install the front No. 1 hood moulding pad.



Hide 2.INSTALL FRONT NO. 1 HOOD MOULDING PAD RH

HINT:

Use the same procedure described for the LH side.


Hide 3.INSTALL FRONT HOOD MOULDING PAD

HINT:

When installing the front hood moulding pad, heat the front hood moulding surface using a heat light.


Standard:
Item Temperature
Front Hood Moulding 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the front hood moulding excessively.


a.

Clean the front hood moulding surface.

i.

Using a heat light, heat the front hood moulding surface.


ii.

Remove the double-sided tape from the front hood moulding surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

for Upper Side:

i.
B280274

Install a new front hood moulding pad.

1.

Remove the peeling paper from the face of a new front hood moulding pad.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.


2.

Install the front hood moulding pad.




c.

for Lower Side:

i.
B280276

Install a new front hood moulding pad.

1.

Remove the peeling paper from the face of a new front hood moulding pad.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.


2.

Install the front hood moulding pad.