Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROCKER PANEL MOULDING
RM1880E _59 Vehicle Exterior _013254 EXTERIOR PANELS / TRIM _0068758 ROCKER PANEL MOULDING A

EXTERIOR PANELS / TRIM  ROCKER PANEL MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL SIDE MUDGUARD LH

HINT:

When installing the side mudguard, heat the vehicle body and side mudguard using a heat light.


Standard:
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Side Mudguard 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the vehicle body or side mudguard excessively.


a.

Clean the vehicle body surface.

i.

Using a heat light, heat the vehicle body surface.


ii.

Remove the double-sided tape from the vehicle body.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Remove the peeling papers from the face of the No. 1 moulding tape and No. 2 moulding tape.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



c.

Attach the 10 clips to install the side mudguard, and then apply No. 1 moulding tape and No. 2 moulding tape to the vehicle body.

HINT:

Press the side mudguard firmly to install it.



d.

Install the screw and 8 retainers.