Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL NO. 2 MOULDING TAPE
When installing the No. 2 moulding tape, heat the side mudguard surface using a heat light.
| Item | Temperature |
|---|---|
| Side Mudguard | 20 to 30°C (68 to 86°F) |
Do not heat the side mudguard excessively.
Clean the side mudguard surface.
Using a heat light, heat the side mudguard surface.
Remove the double-sided tape from the side mudguard surface.
Wipe off any tape adhesive residue with cleaner.
Install a new No. 2 moulding tape as shown in the illustration.
2.INSTALL NO. 1 MOULDING TAPE
When installing the No. 1 moulding tape, heat the side mudguard surface using a heat light.
| Item | Temperature |
|---|---|
| Side Mudguard | 20 to 30°C (68 to 86°F) |
Do not heat the side mudguard excessively.
Clean the side mudguard surface.
Using a heat light, heat the side mudguard surface.
Remove the double-sided tape from the side mudguard surface.
Wipe off any tape adhesive residue with cleaner.
Install a new No. 1 moulding tape as shown in the illustration.
3.INSTALL SIDE MUDGUARD PROTECTOR
When installing the side mudguard protector, heat the side mudguard surface using a heat light.
| Item | Temperature |
|---|---|
| Side Mudguard | 20 to 30°C (68 to 86°F) |
Do not heat the side mudguard excessively.
Clean the side mudguard surface.
Using a heat light, heat the side mudguard surface.
Remove the double-sided tape from the side mudguard surface.
Wipe off any tape adhesive residue with cleaner.
Install a new side mudguard protector as shown in the illustration.