Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL FRONT DOOR INSERT OUTSIDE MOULDING LH
When installing the front door insert outside moulding, heat the front door outside moulding and front door insert outside moulding using a heat light.
| Item | Temperature |
|---|---|
| Front Door Outside Moulding | 20 to 30°C (68 to 86°F) |
| Front Door Insert Outside Moulding | 20 to 30°C (68 to 86°F) |
Do not heat the front door outside moulding or front door insert outside moulding excessively.
Clean the front door outside moulding surface.
Using a heat light, heat the front door outside moulding surface.
Remove the double-sided tape from the front door outside moulding.
Wipe off any tape adhesive residue with cleaner.
Install a new front door insert outside moulding.
Using a heat light, heat the front door outside moulding and a new front door insert outside moulding.
Remove the peeling paper from the face of the front door insert outside moulding.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Install the front door insert outside moulding.
Press the front door insert outside moulding firmly to install it.
2.INSTALL FRONT DOOR OUTSIDE MOULDING LH
When installing the front door outside moulding, heat the front door panel and front door outside moulding using a heat light.
| Item | Temperature |
|---|---|
| Front Door Panel | 40 to 60°C (104 to 140°F) |
| Front Door Outside Moulding | 20 to 30°C (68 to 86°F) |
Do not heat the front door panel or front door outside moulding excessively.
Clean the front door panel surface.
Using a heat light, heat the front door panel surface.
Remove the double-sided tape from the front door panel.
Wipe off any tape adhesive residue with cleaner.
Install a new front door outside moulding.
Using a heat light, heat the front door panel and a new front door outside moulding.
Remove the peeling paper from the face of the front door outside moulding.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Install the front door outside moulding in the position shown in the illustration.
Press the front door outside moulding firmly to install it.
| Area | Measurement (Reference Value) | Area | Measurement (Reference Value) |
|---|---|---|---|
| A | 7.1 mm (0.280 in.) | C | 0.7 to 3.7 mm (0.0276 to 0.146 in.) |
| B | 321.1 to 324.1 mm (12.6 to 12.8 in.) | D | 338.3 to 341.3 mm (13.3 to 13.4 in.) |