Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT DOOR OUTSIDE MOULDING LH
When removing the front door outside moulding, heat the front door panel and front door outside moulding using a heat light.
| Item | Temperature |
|---|---|
| Front Door Panel | 40 to 60°C (104 to 140°F) |
| Front Door Outside Moulding | 20 to 30°C (68 to 86°F) |
Do not heat the front door panel or front door outside moulding excessively.
| *1 | Protective Tape |
| *2 | Wooden Block |
Put protective tape around the front door outside moulding.
Insert piano wire between the front door panel and front door outside moulding.
Tie objects that can serve as handles (for example, wooden blocks) to the piano wire ends.
Pull the piano wire and scrape off the double-sided tape that holds the front door outside moulding to the front door panel.
Be careful not to damage the front door panel.
Remove the front door outside moulding.
2.REMOVE FRONT DOOR INSERT OUTSIDE MOULDING LH
When removing the front door insert outside moulding, heat the front door outside moulding and front door insert outside moulding using a heat light.
| Item | Temperature |
|---|---|
| Front Door Outside Moulding | 20 to 30°C (68 to 86°F) |
| Front Door Insert Outside Moulding | 20 to 30°C (68 to 86°F) |
Do not heat the front door outside moulding or front door insert outside moulding excessively.
| *1 | Protective Tape |
Put protective tape around the front door insert outside moulding.
Using a screwdriver, remove the front door insert outside moulding.
Be careful not to damage the front door outside moulding.
Tape the screwdriver tip before use.