Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR OUTSIDE MOULDING
RM1880E _59 Vehicle Exterior _013254 EXTERIOR PANELS / TRIM _0068760 REAR DOOR OUTSIDE MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR OUTSIDE MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL REAR DOOR INSERT OUTSIDE MOULDING LH

HINT:

When installing the rear door insert outside moulding, heat the rear door outside moulding and rear door insert outside moulding using a heat light.


Standard:
Item Temperature
Rear Door Outside Moulding 20 to 30°C (68 to 86°F)
Rear Door Insert Outside Moulding 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the rear door outside moulding or rear door insert outside moulding excessively.


a.

Clean the rear door outside moulding surface.

i.

Using a heat light, heat the rear door outside moulding surface.


ii.

Remove the double-sided tape from the rear door outside moulding.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Install a new rear door insert outside moulding.

i.

Using a heat light, heat the rear door outside moulding and a new rear door insert outside moulding.


ii.

Remove the peeling paper from the face of the rear door insert outside moulding.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



iii.

Install the rear door insert outside moulding.

HINT:

Press the rear door insert outside moulding firmly to install it.




Hide 2.INSTALL REAR DOOR OUTSIDE MOULDING LH

HINT:

When installing the rear door outside moulding, heat the rear door panel and rear door outside moulding using a heat light.


Standard:
Item Temperature
Rear Door Panel 40 to 60°C (104 to 140°F)
Rear Door Outside Moulding 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the rear door panel or rear door outside moulding excessively.


a.

Clean the rear door panel surface.

i.

Using a heat light, heat the rear door panel surface.


ii.

Remove the double-sided tape from the rear door panel.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Install a new rear door outside moulding.

i.

Using a heat light, heat the rear door panel and a new rear door outside moulding.


ii.

Remove the peeling paper from the face of the rear door outside moulding.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



iii.
B280931
0.74,0.198 1.021,0.448 0.281,0.25 10 false A 0.74,2.51 0.99,2.719 0.25,0.208 10 false B 2.781,0.844 3.01,1.094 0.229,0.25 10 false C 2.375,2.51 2.583,2.74 0.208,0.229 10 false D

Install the rear door outside moulding in the position shown in the illustration.

HINT:

Press the rear door outside moulding firmly to install it.


Standard:
Area Measurement (Reference Value) Area Measurement (Reference Value)
A 18.8 mm (0.740 in.) C 27.9 mm (1.10 in.)
B 338.9 to 341.9 mm (13.3 to 13.5 in.) D 350.3 to 353.3 mm (13.8 to 13.9 in.)