Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR OUTSIDE MOULDING
RM1880E _59 Vehicle Exterior _013254 EXTERIOR PANELS / TRIM _0068760 REAR DOOR OUTSIDE MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR OUTSIDE MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR DOOR OUTSIDE MOULDING LH

HINT:

When removing the rear door outside moulding, heat the rear door panel and rear door outside moulding using a heat light.


Standard:
Item Temperature
Rear Door Panel 40 to 60°C (104 to 140°F)
Rear Door Outside Moulding 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the rear door panel or rear door outside moulding excessively.


a.
B343071
1.49,0.656 0.969,0.771 false 0.927,1.667 0.688,1.552 false 1.01,1.563 1.323,1.719 0.313,0.156 10 false *1 0.74,0.677 1.052,0.833 0.313,0.156 10 false *2
*1 Protective Tape
*2 Wooden Block


Put protective tape around the rear door outside moulding.


b.

Insert piano wire between the rear door panel and rear door outside moulding.


c.

Tie objects that can serve as handles (for example, wooden blocks) to the piano wire ends.


d.

Pull the piano wire and scrape off the double-sided tape that holds the rear door outside moulding to the rear door panel.

NOTICE:

Be careful not to damage the rear door panel.



e.

Remove the rear door outside moulding.


Hide 2.REMOVE REAR DOOR INSERT OUTSIDE MOULDING LH

HINT:

When removing the rear door insert outside moulding, heat the rear door outside moulding and rear door insert outside moulding using a heat light.


Standard:
Item Temperature
Rear Door Outside Moulding 20 to 30°C (68 to 86°F)
Rear Door Insert Outside Moulding 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the rear door outside moulding or rear door insert outside moulding excessively.


a.
B280929
0.396,1.25 0.542,1.25 0.542,1.25 0.813,1.427 false 1.979,0.802 2.042,0.802 2.042,0.802 2.271,1.156 false 0.177,1.146 0.5,1.385 0.323,0.24 10 false *1 1.729,0.688 1.979,0.865 0.25,0.177 10 false *1
*1 Protective Tape


Put protective tape around the rear door insert outside moulding.


b.

Using a screwdriver, remove the rear door insert outside moulding.

NOTICE:

Be careful not to damage the rear door outside moulding.


HINT:

Tape the screwdriver tip before use.