Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BACK DOOR OUTSIDE GARNISH
RM1880E _59 Vehicle Exterior _013254 EXTERIOR PANELS / TRIM _0068762 BACK DOOR OUTSIDE GARNISH A

EXTERIOR PANELS / TRIM  BACK DOOR OUTSIDE GARNISH  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL BACK DOOR OUTSIDE GARNISH PROTECTOR LH

HINT:

When installing the back door outside garnish protector, heat the back door outside garnish surface using a heat light.


Standard:
Item Temperature
Back Door Outside Garnish 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the back door outside garnish excessively.


a.

Clean the back door outside garnish surface.

i.

Using a heat light, heat the back door outside garnish surface.


ii.

Remove the double-sided tape from the back door outside garnish surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.
B281405

Install a new back door outside garnish protector in the position shown in the illustration.


Hide 2.INSTALL BACK DOOR OUTSIDE GARNISH PROTECTOR RH

HINT:

Use the same procedure described for the LH side.


Hide 3.INSTALL BACK DOOR OUTSIDE GARNISH PROTECTOR

HINT:

When installing the back door outside garnish protector, heat the back door outside garnish surface using a heat light.


Standard:
Item Temperature
Back Door Outside Garnish 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the back door outside garnish excessively.


a.

Clean the back door outside garnish surface.

i.

Using a heat light, heat the back door outside garnish surface.


ii.

Remove the double-sided tape from the back door outside garnish surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.
B281404

Install a new back door outside garnish protector in the position shown in the illustration.