Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE CENTER PILLAR BLACK OUT TAPE LH
When removing the center pillar black out tape, heat the vehicle body and center pillar black out tape using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Center Pillar Black Out Tape | 40 to 60°C (104 to 140°F) |
Do not heat the vehicle body or center pillar black out tape excessively.
Pull back an edge of the center pillar black out tape and pull it parallel to the vehicle body to remove it.