Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function) › 2011.07–2013.08
RM1880E _59 Vehicle Exterior _013248 WINDOW / GLASS _0068699 POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function) Y

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:

Use these procedures to troubleshoot the power window control system.


PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

3.PROBLEM SYMPTOMS TABLE
3.PROBLEM SYMPTOMS TABLE
a.

Refer to the Problem Symptoms Table.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B




A

4.OVERALL ANALYSIS AND TROUBLESHOOTING

B

5.REPAIR OR REPLACE
4.OVERALL ANALYSIS AND TROUBLESHOOTING

NEXT

5.REPAIR OR REPLACE
5.REPAIR OR REPLACE
Result:
Result Proceed to
Door window regulator replaced or removed/installed A
Door window regulator not replaced or removed/installed B



A

6.RESET FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

B

7.CONFIRMATION TEST
6.RESET FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
a.

If the power window regulator master switch light is blinking, reset the front power window regulator motor assembly LH.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>INITIALIZATION


Result:
Proceed to
NEXT



NEXT

7.CONFIRMATION TEST
7.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END