Home › Engine / Hybrid System › 2TR-FE STARTING › STARTER › from 2013.08
RM1880E _51 Engine / Hybrid System _013216 2TR-FE STARTING _0068502 STARTER A

2TR-FE STARTING  STARTER  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A221352

Remove the nut and disconnect the lead wire from terminal C.


b.
A221353

Remove the 2 nuts from the starter drive housing assembly while holding the magnet starter switch assembly.


c.
A221354

Pull the magnet starter switch assembly and, while lifting the front part of the magnet starter switch assembly, release the plunger hook from the starter pinion drive lever and remove the magnet starter switch assembly.


Hide 2.REMOVE STARTER YOKE ASSEMBLY

a.
A221355

Using a T25 "TORX" socket wrench, remove the 2 through bolts.


b.
A221356

Remove the starter yoke assembly and commutator end frame assembly from the starter drive housing assembly.


Hide 3.REMOVE STARTER BRUSH HOLDER ASSEMBLY

a.
A224838

Remove the 2 screws from the starter commutator end frame assembly.


b.
A187221

Remove the starter commutator end frame assembly from the starter yoke assembly.

NOTICE:

While holding down the lead wire, remove the starter commutator end frame.



c.
A215926

Disconnect the 4 brushes from the starter brush holder assembly.

i.

Using a screwdriver, hold back the spring.


ii.

Disconnect the brush from the brush holder assembly.



d.

Remove the brush holder assembly.


Hide 4.REMOVE STARTER ARMATURE ASSEMBLY

a.
A202438

Remove the starter armature assembly from the starter yoke assembly.


Hide 5.REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

a.
A221359

Remove the starter armature plate from the starter yoke assembly or starter center bearing clutch sub-assembly.


b.
A221360

Remove the 3 planetary gears from the starter center bearing clutch sub-assembly.


c.
A224836

Remove the starter pinion drive lever, rubber plate and starter center bearing clutch sub-assembly from the starter drive housing assembly.