Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.INSTALL FRONT SEAT CUSHION COVER LH
Install the front seat cushion cover LH to the front seat inner belt assembly LH.
Use the same procedure described for the RH side.
2.INSTALL FRONT SEAT INNER BELT ASSEMBLY LH
Install the front seat belt anchor plate.
| *1 | Protruding Part |
Install the front seat inner belt assembly LH with the nut.
Do not overlap the anchor part of the front seat inner belt assembly LH and protruding part of the front seat cushion frame sub-assembly LH.
Attach the wire harness to the clamp.
Attach the clamp.
3.INSTALL FRONT SEAT INNER BELT ASSEMBLY RH
| *1 | Protruding Part |
w/ Front Passenger Seat Belt Warning System:
Install the front seat belt anchor plate.
Install the front seat inner belt assembly RH with the nut.
Do not overlap the anchor part of the front seat inner belt assembly RH and protruding part of the front seat cushion frame sub-assembly RH.
Attach the wire harness to the clamp.
| *a | Front |
Connect the connector and attach the 2 clamps as shown in the illustration.
| *1 | Hog Ring Pliers |
Using hog ring pliers, connect the cover to the front seat cushion frame sub-assembly RH with new hog rings.
w/o Front Passenger Seat Belt Warning System:
Install the front seat belt anchor plate.
| *1 | Protruding Part |
Install the front seat inner belt assembly RH with the nut.
Do not overlap the anchor part of the front seat inner belt assembly RH and protruding part of the front seat cushion frame sub-assembly RH.
4.INSTALL FRONT SEAT ASSEMBLY