1.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY
| *1 | Protrusion |
| *2 | Groove |
Install a new gasket to the intake manifold.
Align the protrusion of the gasket with the groove of the intake manifold.
Install the throttle body with motor assembly with the 4 bolts.
Connect the 2 water by-pass hoses to the throttle body with motor assembly.
Connect the throttle position sensor and control motor connector.
2.INSTALL INTAKE AIR CONNECTOR
Install the intake air connector with the 2 bolts, and then tighten the 2 hose clamps.
Connect the No. 2 PCV hose.
Connect the vacuum hose.
3.ADD ENGINE COOLANT
4.PERFORM INITIALIZATION
Perform the following procedure after replacing or removing and installing the ECM, throttle body or any throttle body components or after reconnecting the battery cable. The following procedure should also be performed if the throttle body is cleaned.
Disconnect the EFI and ETCS fuses at the same time. Wait at least 60 seconds and reconnect the fuses.
Turn the ignition switch to ON without operating the accelerator pedal.
If the accelerator pedal is operated, perform the above steps again.
Connect the tester to the DLC3 and clear the DTCs (See page Engine / Hybrid System>2TR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).
Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the cooler is switched off after the engine is warmed up.
| Condition | Specified Condition |
|---|---|
| Air conditioning switched off | 600 to 700 rpm |
Be sure to perform this step with all accessories off.
Make sure that the shift lever is in N or P.
Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Sensor Position.
| Tester Display |
|---|
| Throttle Sensor Position |
Fully depress the accelerator pedal and check that the value is 60% or more.
Perform a road test and confirm that there are no abnormalities.
5.INSPECT FOR COOLANT LEAK