Home › General › SPECIFICATIONS › 2TR-FE STARTING › from 2013.08
RM1880E _V1 General _013207 SPECIFICATIONS _0068429 2TR-FE STARTING F

SPECIFICATIONS  2TR-FE STARTING  SERVICE DATA  


Starter assembly No-load characteristics current Standard current 90 A or less at 11.5 V
Starter armature assembly Segments Standard resistance Below 1 Ω
Segment - Armature coil core Standard resistance 10 kΩ or higher
Commutator diameter Standard diameter 29.0 mm (1.14 in.)
Minimum diameter 28.0 mm (1.10 in.)
Commutator circle runout Maximum commutator runout 0.05 mm (0.00197 in.)
Commutator undercut depth Standard undercut depth 0.7 mm (0.0276 in.)
Minimum undercut depth 0.2 mm (0.00787 in.)
Starter brush holder assembly Brush length Standard length 14.4 mm (0.567 in.)
Minimum length 9.0 mm (0.354 in.)
Brush spring load Standard spring load 16 to 20 N (1.7 to 2.0 kgf, 3.6 to 4.5 lbf)
Minimum spring load 6.7 N (0.7 kgf, 1.5 lbf)
Positive brush - Negative brush Standard resistance 10 kΩ or higher
Magnet starter switch assembly Terminal 50 - Terminal C Standard resistance Below 1 Ω
Terminal 50 - Switch body Standard resistance Below 2 Ω