Last Modified: 6-7-2017 6.8:8.0.40 Doc ID: RM0000008XN005X
Model Year Start: 2006 Model: Land Cruiser Prod Date Range: [05/2005 -           ]
Title: EXTERIOR: OUTSIDE MOULDING: REMOVAL; 2006 MY Land Cruiser [05/2005 -        ]

REMOVAL

HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.
  • When removing the moulding, heat the vehicle body and moulding using a heat light.

Standard heating temperature:

Item

Temperature

Vehicle Body

40 to 60°C (104 to 140°F)

Moulding

20 to 30°C (68 to 86°F)

NOTICE:

Do not heat the vehicle body and moulding excessively.

1. REMOVE FRONT FENDER MOULDING OUTSIDE LH

(a) Remove the screw.

(b) Put protective tape around the moulding.

(c) Using a heat light, heat the moulding.

(d) Cut the double-sided tape with a knife.

NOTICE:

  • If reusing the moulding, take care not to damage the moulding.
  • Be careful not to damage the vehicle body.

(e) Using a screwdriver, detach the 2 claws and remove the moulding.

HINT:

Tape the screwdriver tip before use.

2. REMOVE FRONT DOOR MOULDING OUTSIDE LH

(a) Put protective tape around the moulding.

(b) Using a heat light, heat the moulding.

(c) Cut the double-sided tape with a knife.

NOTICE:

  • If reusing the moulding, take care not to damage the moulding.
  • Be careful not to damage the vehicle body.

(d) Using a screwdriver, detach the 6 claws and remove the moulding.

HINT:

Tape the screwdriver tip before use.

3. REMOVE REAR DOOR MOULDING OUTSIDE LH

(a) Put protective tape around the moulding.

(b) Using a heat light, heat the moulding.

(c) Cut the double-sided tape with a knife.

NOTICE:

  • If reusing the moulding, take care not to damage the moulding.
  • Be careful not to damage the vehicle body.

(d) Using a screwdriver, detach the 4 claws and remove the moulding.

HINT:

Tape the screwdriver tip before use.

4. REMOVE REAR DOOR MOULDING OUTSIDE UPPER REAR LH

(a) Put protective tape around the moulding.

(b) Using a heat light, heat the moulding.

(c) Cut the double-sided tape with a knife.

NOTICE:

  • If reusing the moulding, take care not to damage the moulding.
  • Be careful not to damage the vehicle body.

(d) Remove the moulding.

5. REMOVE QUARTER MOULDING OUTSIDE LH

(a) Put protective tape around the moulding.

(b) Using a heat light, heat the moulding.

(c) Cut the double-sided tape with a knife.

NOTICE:

  • If reusing the moulding, take care not to damage the moulding.
  • Be careful not to damage the vehicle body.

(d) Using a screwdriver, detach the 4 claws and remove the moulding.

HINT:

Tape the screwdriver tip before use.