Last Modified: 6-7-2017 6.8:8.0.40 Doc ID: RM0000017S3001X
Model Year Start: 2006 Model: Land Cruiser Prod Date Range: [05/2005 -           ]
Title: 2UZ-FE EMISSION CONTROL: CANISTER: INSTALLATION; 2006 MY Land Cruiser [05/2005 -        ]

INSTALLATION

1. INSTALL CANISTER ASSEMBLY

(a) Install the canister with the 3 bolts.

Torque:

14.7 N·m {150 kgf·cm, 11ft·lbf}

(b) Connect the 2 tubes and hose.

(1) Connect the air inlet line tube to the canister (leak detection pump).

(2) Connect the vent line tube to the canister filter.

(3) Connect the purge line hose.

HINT:

Install the hose to the canister, and then attach the retainer.

(c) Connect the connector.

(d) Secure the wire with the clamp.

2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

3. PERFORM INITIALIZATION

(a) Perform initialization 2006 MY Land Cruiser [05/2005 -        ]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION .

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.