REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

HINT:

At the time of installation, perform initialization .

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

2. REMOVE INSTRUMENT PANEL REGISTER

(a) Disengage the 12 clips and remove the center resistors, then disconnect the connectors.

3. REMOVE INTEGRATION CONTROL PANEL ASSEMBLY

(a) Remove the 4 bolts.

(b) Disengage the 7 clips and remove the integration control panel assembly, then disconnect the connectors.

4. REMOVE A/C AMPLIFIER ASSEMBLY (w/ Navigation System)

(a) Disconnect the connector clamp.

(b) Remove the 3 screws, 4 bolts and radio receiver bracket LH.

(c) Remove the 2 screws and A/C amplifier.

5. REMOVE MULTI-DISPLAY (w/ Navigation System)

(a) Remove the 2 screws, 2 bolts and EMV.

6. REMOVE INTEGRATION CONTROL PANEL (w/ Navigation System)

(a) Disconnect the connector clamps.

(b) Remove the screw, the 2 bolts and radio receiver bracket RH.

(c) Remove the integration control panel from the radio receiver.

7. REMOVE HEATER CONTROL PANEL ASSEMBLY (w/o Navigation System)

(a) Disconnect the connector clamp.

(b) Remove the 6 bolts and radio receiver bracket LH.

(c) Disconnect the connector clamp.

(d) Remove the 6 bolts and radio receiver bracket RH.

(e) Remove the heater control panel.