Last Modified: 6-7-2017 6.8:8.0.40 Doc ID: RM00000195F001X
Model Year Start: 2006 Model: Land Cruiser Prod Date Range: [05/2005 -           ]
Title: WINDSHIELD / WINDOWGLASS: QUARTER WINDOW GLASS: REMOVAL; 2006 MY Land Cruiser [05/2005 -        ]

REMOVAL

HINT:

Use the same procedures for the RH side and LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE ROOF HEADLINING REAR TRIM

(a) Using a screwdriver, remove the roof headlining rear trim.

HINT:

Tape the screwdriver tip before use.

3. REMOVE REAR NO. 2 SEAT

(a) Remove the rear NO. 2 seat 2006 MY Land Cruiser [05/2005 -        ]; SEAT: REAR NO. 2 SEAT ASSEMBLY: DISASSEMBLY .

4. REMOVE REAR MAT SET PLATE

(a) Remove the 5 screws.

(b) Using a screwdriver, remove the set plate.

HINT:

Tape the screwdriver tip before use.

5. REMOVE STRIKER PLATE 2006 MY Land Cruiser [05/2005 -        ]; INTERIOR: ROOF HEADLINING: REMOVAL+

6. REMOVE REAR FLOOR CARPET

7. REMOVE REAR NO. 2 SEAT OUTER BELT FLOOR ANCHOR

8. REMOVE REAR NO. 1 SEAT OUTER BELT FLOOR ANCHOR

9. REMOVE REAR DOOR SCUFF PLATE

10. REMOVE REAR DOOR OPENING TRIM

11. REMOVE QUARTER TRIM PANEL

(a) Remove the quarter trim jack cover.

(b) Using a clip remover, remove the 2 clips.

(c) Remove the trim panel, and then disconnect the connector.

12. REMOVE REAR NO. 2 SEAT OUTER BELT SHOULDER ANCHOR

13. REMOVE REAR NO. 1 SEAT OUTER BELT SHOULDER ANCHOR

14. REMOVE UPPER ROOF SIDE INNER GARNISH

(a) Using a screwdriver, remove the 2 assist grip plugs, then remove the 2 screws and assist grip.

HINT:

Tape the screwdriver tip before use.

(b) Using a clip remover, remove the clip.

(c) Using a screwdriver, remove the garnish.

HINT:

Tape the screwdriver tip before use.

15. REMOVE QUARTER WINDOW GLASS

(a) Disconnect the connector.

(b) w/ Antenna:

Disconnect the connector.

(c) Remove the 2 bolts.

(d) Remove the 2 nuts and window glass.

16. REMOVE QUARTER WINDOW WEATHERSTRIP

17. REMOVE QUARTER BELT MOULDING

(a) Remove the screw.

(b) Using a screwdriver, remove the moulding.

HINT:

Tape the screwdriver tip before use.

18. REMOVE REAR QUARTER WINDOW MOTOR

(a) Remove the screw and window motor.

19. REMOVE QUARTER WINDOW LOCK

(a) Remove the screw and window lock.