SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION; 2006 MY Land Cruiser [05/2005

Last Modified: 6-7-2017	6.8:8.0.40	Doc ID: RM000001BGZ002X
Model Year Start: 2006	Model: Land Cruiser	Prod Date Range: [05/2005 - ]
Title: SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION; 2006 MY Land Cruiser [05/2005 - ]

INSTALLATION

CAUTION:

Be sure to read the precautionary notices concerning the SRS airbag system before servicing .

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY

(a) Install the airbag sensor with the 3 bolts.

Torque:

17.5 N·m {178 kgf·cm, 13ft·lbf}

NOTICE:

If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(b) Connect the airbag sensor connectors.

2. INSTALL INSTRUMENT CLUSTER FINISH PANEL CENTER LOWER

3. INSTALL FRONT CONSOLE BOX

4. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY

5. INSTALL CONSOLE PANEL SUB-ASSEMBLY UPPER

6. INSTALL TRANSFER SHIFT LEVER

7. INSTALL FRONT SEAT ASSEMBLY LH

(a) Install the front seat assembly .

8. INSTALL FRONT SEAT ASSEMBLY RH

(a) Install the front seat assembly .

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

10. PERFORM INITIALIZATION

(a) Perform initialization .

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

11. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light .