| Last Modified: 6-7-2017 | 6.8:8.0.40 | Doc ID: RM000001CGV000X |
| Model Year Start: 2006 | Model: Land Cruiser | Prod Date Range: [05/2005 - ] |
| Title: TIRE AND WHEEL: TIRE PRESSURE WARNING RECEIVER: REMOVAL; 2006 MY Land Cruiser [05/2005 - ] | ||
REMOVAL
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
(a)
Remove the lower frame bracket garnish
![2006 MY Land Cruiser [05/2005 - ]; MIRROR: OUTER REAR VIEW MIRROR: REMOVAL](../../../../stylegraphics/info.gif "2006 MY Land Cruiser [05/2005 - ]; MIRROR: OUTER REAR VIEW MIRROR: REMOVAL")
.
3. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY
(a)
Remove the regulator switch
.
4. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL
(a)
Remove the inside handle bezel
.
5. REMOVE NO. 1 DOOR INSIDE HANDLE BEZEL
(a)
Remove the inside handle bezel
.
6. REMOVE FRONT DOOR COURTESY LIGHT
(a)
Remove the courtesy light
.
7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
(a)
Remove the trim board
.
8. REMOVE TWEETER SPEAKER
(a)
Remove the tweeter speaker
.
9. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
(a) w/ Tire pressure monitor receiver:
(1)
Remove the rear view mirror
.
|
|