| Last Modified: 6-7-2017 | 6.8:8.0.40 | Doc ID: RM0000018T5003X |
| Model Year Start: 2007 | Model: Land Cruiser | Prod Date Range: [08/2006 - ] |
| Title: AIR CONDITIONING: AIR CONDITIONING CONTROL ASSEMBLY: REMOVAL; 2007 MY Land Cruiser [08/2006 - ] | ||
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
HINT:
At the time of installation, perform initialization
![2007 MY Land Cruiser [08/2006 - ]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION](../../../../stylegraphics/info.gif "2007 MY Land Cruiser [08/2006 - ]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION")
.
NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
2. REMOVE INSTRUMENT PANEL REGISTER
|
(a) Disengage the 12 clips and remove the center resistors, then disconnect the connectors. |
|
3. REMOVE INTEGRATION CONTROL PANEL ASSEMBLY
|
(a) Remove the 4 bolts. |
|
(b) Disengage the 7 clips and remove the integration control panel assembly, then disconnect the connectors.
4. REMOVE A/C AMPLIFIER ASSEMBLY (w/ Navigation System)
|
(a) Disconnect the connector clamp. |
|
(b) Remove the 3 screws, 4 bolts and radio receiver bracket LH.
|
(c) Remove the 2 screws and A/C amplifier. |
|
5. REMOVE MULTI-DISPLAY (w/ Navigation System)
|
(a) Remove the 2 screws, 2 bolts and EMV. |
|
6. REMOVE INTEGRATION CONTROL PANEL (w/ Navigation System)
|
(a) Disconnect the connector clamps. |
|
(b) Remove the screw, the 2 bolts and radio receiver bracket RH.
(c) Remove the integration control panel from the radio receiver.
7. REMOVE HEATER CONTROL PANEL ASSEMBLY (w/o Navigation System)
|
(a) Disconnect the connector clamp. |
|
(b) Remove the 6 bolts and radio receiver bracket LH.
|
(c) Disconnect the connector clamp. |
|
(d) Remove the 6 bolts and radio receiver bracket RH.
(e) Remove the heater control panel.
|
|