| Last Modified: 6-7-2017 | 6.8:8.0.40 | Doc ID: RM00000195F003X |
| Model Year Start: 2007 | Model: Land Cruiser | Prod Date Range: [08/2006 - ] |
| Title: WINDSHIELD / WINDOWGLASS: QUARTER WINDOW GLASS: REMOVAL; 2007 MY Land Cruiser [08/2006 - ] | ||
REMOVAL
HINT:
Use the same procedures for the RH side and LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
|
2. REMOVE ROOF HEADLINING REAR TRIM (a) Using a screwdriver, remove the roof headlining rear trim. HINT: Tape the screwdriver tip before use. |
|
3. REMOVE REAR NO. 2 SEAT
(a)
Remove the rear NO. 2 seat
![2007 MY Land Cruiser [08/2006 - ]; SEAT: REAR NO. 2 SEAT ASSEMBLY: DISASSEMBLY](../../../../stylegraphics/info.gif "2007 MY Land Cruiser [08/2006 - ]; SEAT: REAR NO. 2 SEAT ASSEMBLY: DISASSEMBLY")
.
|
4. REMOVE REAR MAT SET PLATE (a) Remove the 5 screws. (b) Using a screwdriver, remove the set plate. HINT: Tape the screwdriver tip before use. |
|
5.
REMOVE STRIKER PLATE
6. REMOVE REAR FLOOR CARPET
7. REMOVE REAR NO. 2 SEAT OUTER BELT FLOOR ANCHOR
8. REMOVE REAR NO. 1 SEAT OUTER BELT FLOOR ANCHOR
9. REMOVE REAR DOOR SCUFF PLATE
10. REMOVE REAR DOOR OPENING TRIM
|
11. REMOVE QUARTER TRIM PANEL (a) Remove the quarter trim jack cover. (b) Using a clip remover, remove the 2 clips. (c) Remove the trim panel, and then disconnect the connector. |
|
12. REMOVE REAR NO. 2 SEAT OUTER BELT SHOULDER ANCHOR
13. REMOVE REAR NO. 1 SEAT OUTER BELT SHOULDER ANCHOR
|
14. REMOVE UPPER ROOF SIDE INNER GARNISH (a) Using a screwdriver, remove the 2 assist grip plugs, then remove the 2 screws and assist grip. HINT: Tape the screwdriver tip before use. (b) Using a clip remover, remove the clip. (c) Using a screwdriver, remove the garnish. HINT: Tape the screwdriver tip before use. |
|
|
15. REMOVE QUARTER WINDOW GLASS (a) Disconnect the connector. (b) w/ Antenna: Disconnect the connector. (c) Remove the 2 bolts. (d) Remove the 2 nuts and window glass. |
|
16. REMOVE QUARTER WINDOW WEATHERSTRIP
|
17. REMOVE QUARTER BELT MOULDING (a) Remove the screw. (b) Using a screwdriver, remove the moulding. HINT: Tape the screwdriver tip before use. |
|
|
18. REMOVE REAR QUARTER WINDOW MOTOR (a) Remove the screw and window motor. |
|
19. REMOVE QUARTER WINDOW LOCK
(a) Remove the screw and window lock.
|
|