Last Modified: 6-7-2017 6.8:8.0.40 Doc ID: RM000001B5P002X
Model Year Start: 2007 Model: Land Cruiser Prod Date Range: [08/2006 -           ]
Title: NAVIGATION: NAVIGATION SYSTEM: Cursor or Map Rotates when Vehicle Stopped; 2007 MY Land Cruiser [08/2006 -        ]

Cursor or Map Rotates when Vehicle Stopped

INSPECTION PROCEDURE

PROCEDURE

1.

RECHECK (VEHICLE ON DISPLAY NOT ROTATING, TURN IGNITION SWITCH FROM OFF TO ON AGAIN.)
OK

NORMAL (WHILE VEHICLE WAS ROTATING, IGNITION SWITCH WAS TURNED ON.)

NG

2.

CHECK DTC (DTC NO. 58-10)

(a) Check for the DTC (is "58-10" displayed in the unit check mode of the navigation ECU?) 2007 MY Land Cruiser [08/2006 -        ]; NAVIGATION: NAVIGATION SYSTEM: DTC CHECK / CLEAR .

OK:

No DTC(s) is output.

NG

REPLACE NAVIGATION ECU

OK

3.

CHECK DTC (DTC NO. 58-43)

(a) Check for the DTC (is "58-43" displayed in the unit check mode of the navigation ECU?) 2007 MY Land Cruiser [08/2006 -        ]; NAVIGATION: NAVIGATION SYSTEM: DTC CHECK / CLEAR .

OK:

No DTC(s) is output.

NG

REPAIR OR REPLACE SPD TERMINAL WIRE HARNESS

OK

4.

CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)

(a) Enter the Navigation Check mode (Vehicle Sensors) 2007 MY Land Cruiser [08/2006 -        ]; NAVIGATION: NAVIGATION SYSTEM: DTC CHECK / CLEAR .

(b) Check the speed and gyro.

OK

REPLACE NAVIGATION ECU

NG

REPAIR OR REPLACE HARNESS AND CONNECTOR (NAVIGATION ECU - MULTI-DISPLAY)