|
Last Modified: 6-7-2017 |
6.8:8.0.40 |
Doc ID: RM000001CHJ001X |
|
Model Year Start: 2007 |
Model: Land Cruiser |
Prod Date Range: [08/2006 -
] |
|
Title:
SLIDING ROOF: SLIDING ROOF SYSTEM: INSPECTION; 2007 MY Land Cruiser [08/2006 - ]
|
INSPECTION
|
1. INSPECT SLIDE ROOF MOTOR SWITCH
OK:
|
Switch Position
|
Tester Connection
|
Specified Condition
|
|
SLIDE OPEN
|
3 - 5
|
Continuity
|
|
SLIDE OFF
|
-
|
No continuity
|
|
SLIDE CLOSE
|
3 - 4
|
Continuity
|
|
TILT DOWN
|
2 - 3
|
Continuity
|
|
TILT OFF
|
-
|
No continuity
|
|
TILT UP
|
1 - 3
|
Continuity
|
If the continuity is not as specified, replace the switch.
|
|
2. INSPECT SLIDING ROOF CONTROL ASSEMBLY CIRCUIT
|
(a) Disconnect the connector from the ECU and inspect the connector on the wire harness side, as shown in the chart.
OK:
|
Tester Connection
|
Condition
|
Specified Condition
|
|
1 - Ground
|
Constant
|
Continuity
|
|
7 - Ground
|
Constant
|
Continuity
|
|
4 - Ground
|
Slide roof motor switch (TILT) OFF or CLOSE
|
No continuity
|
|
4 - Ground
|
Slide roof motor switch (TILT) UP
|
Continuity
|
|
3 - Ground
|
Slide roof motor switch (TILT) OFF or UP
|
No continuity
|
|
3 - Ground
|
Slide roof motor switch (TILT) DOWN
|
Continuity
|
|
9 - Ground
|
Slide roof motor switch (SLIDE) OFF or CLOSE
|
No continuity
|
|
9 - Ground
|
Slide roof motor switch (SLIDE) OPEN
|
Continuity
|
|
10 - Ground
|
Slide roof motor switch (SLIDE) OFF or OPEN
|
No continuity
|
|
10 - Ground
|
Sliding roof motor switch (SLIDE) CLOSE
|
Continuity
|
OK:
|
Tester Connection
|
Condition
|
Specified Condition
|
|
5 - Ground
|
Constant
|
Battery positive voltage
|
|
8 - Ground
|
Ignition switch OFF or ACC
|
No voltage*
|
|
8 - Ground
|
Ignition switch ON
|
Battery positive voltage
|
|
|
|
