2013-2015 Land Cruiser Prado · Service Manual Power Source / Network

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE GENERATOR WITH CLUTCH PULLEY
  1. Remove the generator pulley cap.

  1. Mount the generator in a vise between aluminum plates.

  1. A224863E01
    Install SST (A) and (B) to the pulley as shown in the illustration.
    SST
    09820-63021  

    NOTICE:
    Securely attach SST to the generator pulley and generator rotor shaft.

  1. A224864E01
    Use a wrench to hold SST (A) and turn SST (B) counterclockwise to loosen the generator with clutch pulley.
    Text in Illustration 
    *a
    Hold
    V100135
    Turn

    NOTICE:
    Be careful as the generator pulley or generator rotor shaft may be damaged if the position of SST is not securely maintained while performing this operation.

  1. Remove SST from the generator.

  1. Remove the pulley.


2. REMOVE GENERATOR REAR END COVER

  1. A079302
    Remove the 3 nuts and generator rear end cover.


3. REMOVE TERMINAL INSULATOR

  1. A079342E01
    Remove the terminal insulator.


4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

  1. A079303
    Remove the 2 screws and generator brush holder assembly.


5. REMOVE GENERATOR COIL ASSEMBLY

  1. A079304
    Remove the 4 through bolts.

  1. A115875E02
    Using SST, remove the generator coil.
    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)
    Text in Illustration 
    *a
    Hold
    V100135
    Turn

  1. Remove the generator washer.


6. REMOVE GENERATOR ROTOR ASSEMBLY
  1. Remove the generator rotor from the drive end frame.


7. CHECK GENERATOR DRIVE END FRAME BEARING

  1. A079307
    Check that the bearing is not rough or worn.
    If necessary, replace the generator drive end frame bearing.


8. REMOVE GENERATOR DRIVE END FRAME BEARING

  1. A079311
    Remove the 4 screws and bearing retainer.

  1. A115881E01
    Using SST, tap out the bearing.
    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)

← REMOVAL (from Aug 2014)INSPECTION (from Aug 2013) →