2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE STARTER YOKE ASSEMBLY

  1. A199399
    Remove the nut, and then disconnect the lead wire from terminal C.

  1. Remove the 2 through bolts.

  1. Pull out the starter yoke together with the starter armature.

  1. Remove the O-ring from the starter yoke.


2. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A199400
    Remove the 2 screws and magnet starter switch.

  1. A229861E01
    Remove the idle gear, retainer, clutch roller, return spring and starter clutch from the starter drive housing.
    Text in Illustration 
    *1
    Starter Drive Housing
    *2
    Starter Clutch
    *3
    Return Spring
    *4
    Clutch Roller
    *5
    Retainer
    *6
    Idle Gear

  1. A115020E03
    Using a magnet hand, remove the steel ball from the starter clutch.
    Text in Illustration 
    *1
    Magnet Hand


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. A173938
    Remove the 2 screws and commutator end frame from the starter yoke.

  1. Remove the dust starter protector from the commutator end frame.

  1. Remove the O-ring from the starter yoke.

  1. Disconnect the 4 brushes from the starter brush holder.

    1. A050090E01
      Using a screwdriver, hold back the brush spring.

    2. Disconnect the brush from the brush holder.

  1. Remove the brush holder from the starter armature.


4. REMOVE STARTER ARMATURE ASSEMBLY

  1. A173939
    Remove the starter armature from the starter yoke.

← REMOVAL (from Aug 2014)INSPECTION (from Aug 2013) →