2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE STARTER YOKE ASSEMBLY

  1. P013020E01
    Remove the nut and disconnect the lead wire from terminal C.

  1. A074859E01
    Remove the 2 bolts and 2 O-rings.

  1. Pull out the starter yoke together with the starter armature.

  1. Remove the O-ring from the starter yoke.


2. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A102596
    Remove the 2 bolts and magnet starter switch.

  1. A222616E01
    Remove the return spring, pinion gear, idler gear, clutch roller, retainer and starter clutch from the starter housing.
    Text in Illustration 
    *1
    Return Spring
    *2
    Pinion Gear
    *3
    Idler Gear
    *4
    Clutch Roller
    *5
    Retainer
    *6
    Starter Clutch
    *7
    Starter Housing

  1. A115020E04
    Using a magnet hand, remove the steel ball from the starter clutch hole.
    Text in Illustration 
    *1
    Magnet Hand


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

N000562E03
  1. Disconnect the 4 starter yoke brushes from the starter brush holder.

    1. Using a screwdriver, pull back the spring.

    2. Disconnect the brush from the starter brush holder.

  1. Remove the starter brush holder from the starter yoke.


4. REMOVE STARTER ARMATURE ASSEMBLY

  1. A222477
    Using a plastic-faced hammer, tap the starter yoke to remove the starter armature from the starter yoke.

← REMOVAL (from Aug 2014)INSPECTION (from Aug 2013) →