2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL LH
  1. Remove the 5 clips and frame seal.


3. REMOVE REAR ENGINE UNDER COVER ASSEMBLY
  1. Remove the 4 bolts and rear engine under cover.


4. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

  1. C215613
    Remove the 2 bolts and clip, and then disconnect the release cylinder.


5. REMOVE STARTER ASSEMBLY
  1. Remove the terminal cap.

  1. A224848
    Remove the nut and disconnect the starter wire.

  1. Disconnect the starter connector.

  1. A246032
    for Automatic Transmission:
    Remove the bolt, 2 nuts and starter assembly.

  1. A223731
    for Manual Transmission:
    Remove the bolt, nut and starter assembly.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →