2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE STARTER YOKE ASSEMBLY

  1. A115884E02
    Remove the nut and disconnect the lead wire from terminal C.
    Text in Illustration 
    *1
    Terminal C

  1. Remove the 2 through bolts.

  1. Pull out the starter yoke with the armature.

  1. Remove the felt washer from the starter armature.


2. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A102626
    Remove the 3 screws and magnet starter switch.

  1. A158379E02
    Remove the return spring, pinion gear, idler gear, clutch roller, retainer and starter clutch from the starter housing.
    Text in Illustration 
    *1
    Return Spring
    *2
    Idler Gear
    *3
    Clutch Roller
    *4
    Retainer
    *5
    Starter Clutch
    *6
    Starter Housing

  1. A197146E03
    Using a magnet hand, remove the steel ball from the starter clutch.
    Text in Illustration 
    *1
    Magnet Hand


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. A102628
    Remove the 2 screws and commutator end frame from the starter yoke.

  1. A102629
    Disconnect the 4 starter yoke brushes from the brush holder.

    1. Using a screwdriver, pull back the spring.

    2. Disconnect the brush from the brush holder.

  1. Remove the brush holder from the starter armature.


4. REMOVE STARTER ARMATURE ASSEMBLY
  1. Remove the starter armature from the starter yoke.

← REMOVAL (from Aug 2014)INSPECTION (from Aug 2013) →